THE PRISMABORE - MOULD CENTER

Large capacity machine dedicated for machining of mould and heat exchanger plates, hydraulic manifolds. Finishing operations to deep hole drilling e.g. counterboring, tapping, threading and milling. True milling spindle ISO 40 for auxiliary operations.

Standart Specifications

Column type machine with 2 spindles and 5 Axis FANUC or HEIDENHEIN CNC Control

Gundrilling Diameter:	5 mm - 50 mm

Drilling Depth:	2000 mm

Rotary Table Size:	quare 1250, or 2000, or 2500

X Axis Travel	up to 3500 mm

Y Axis Travel	1500 mm

Weigth on Table:	5, 15, 25 or 40 tons

Auxilliary Operations:	milling, counterboring, tapping, threading

Unique Characteristics

Capability of the drilling and milling heads to travel over the table (Ram stroke: 1000mm). The spindles are reaching the center of the table; only one clamping needed to machine all 4 faces even on smaller plates.
Unique chipbox construction combined with 3 position (0, 200 and 500mm) milling quill spindle allows drilling and milling angled holes: 40 degrees without the need for extended bushes.
Pressure compensating pump allows continuos drilling, no need to plug the crossing holes.
Special design of the chipbox allows the spindles to travel very close to table surface.
Enclosed guarding perimeter to keep a safe and clean environment.
Various machine configurations depending on the table size, mobility and capacity.

Customized Mollart Software

Special deep hole drilling macros.
Special deep hole drilling cycles for drilling intersecting holes while spindle is ramping up and down.
Elaborated probing cycles for ease of component set-up.
Spindle speed, feed and coolant monitoring.
Tool management.
Rapid Interrupt Cycle

Impressum